1 files changed, 0 insertions, 80 deletions
diff --git a/docs/source/lang/api/pinmode.rst b/docs/source/lang/api/pinmode.rst
deleted file mode 100644
index 643e26e..0000000
--- a/docs/source/lang/api/pinmode.rst
+++ /dev/null
@@ -1,80 +0,0 @@
-.. highlight:: cpp
-
-.. _lang-pinmode:
-
-pinMode()
-=========
-
-.. contents:: Contents
-   :local:
-
-Library Documentation
----------------------
-
-.. doxygenfunction:: pinMode
-
-.. _lang-pinmode-wiringpinmode:
-
-.. doxygenenum:: WiringPinMode
-
-Discussion
-----------
-
-pinMode() is usually called within :ref:`lang-setup` in order to
-configure a pin for a certain usage (although it may be called
-anywhere).
-
-Example
--------
-
-This example uses pinMode() to set up the pin connected to the
-built-in LED as an output.  Once this is done,
-:ref:`lang-digitalwrite` can be used to turn the pin ``HIGH`` and
-``LOW``, which turn the LED on and off.
-
-::
-
-    void setup() {
-        pinMode(BOARD_LED_PIN, OUTPUT);      // sets the LED pin as output
-    }
-
-    void loop() {
-        digitalWrite(BOARD_LED_PIN, HIGH);   // sets the LED on
-        delay(1000);                         // waits for a second
-        digitalWrite(BOARD_LED_PIN, LOW);    // sets the LED off
-        delay(1000);                         // waits for a second
-    }
-
-Arduino Compatibility
----------------------
-
-.. TODO check out Arduino vs. Maple static discilpline cutoffs to
-.. ensure accuracy of following:
-
-On Maple, pinMode() supports the ``INPUT`` and ``OUTPUT`` modes in the
-same way as Arduino (however, remember that the Maple, as a 3.3V
-device, will only drive 3.3V to an ``OUTPUT`` pin that has been set
-``HIGH``, instead of 5V like on Arduino).
-
-``INPUT_ANALOG`` and ``PWM`` modes were added because the Maple
-doesn't separate the analog and digital pins the same way Arduino
-does.  Unlike on Arduino, you **must call** pinMode() to set up a pin
-for these purposes before a call to, e.g., :ref:`lang-analogRead`.
-This should only add a few lines to your :ref:`lang-setup` function.
-
-.. TODO [0.1.0] verify following before putting it in:
-
-.. ``OUTPUT_OPEN_DRAIN``, ``INPUT_PULLUP``, ``INPUT_PULLDOWN``, and
-.. ``PWM_OPEN_DRAIN`` modes represent functionality not currently
-.. available on Arduino boards.
-
-See Also
---------
-
-- :ref:`lang-board-values`
-- :ref:`lang-constants`
-- :ref:`lang-digitalwrite`
-- :ref:`lang-digitalread`
-- :ref:`gpio`
-
-.. include:: /arduino-cc-attribution.txt