1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
|
.. highlight:: cpp
.. _lang-pinmode:
pinMode()
=========
.. contents:: Contents
:local:
Library Documentation
---------------------
.. doxygenfunction:: pinMode
.. _lang-pinmode-wiringpinmode:
.. doxygenenum:: WiringPinMode
Discussion
----------
``pinMode()`` is usually called within :ref:`lang-setup` in order to
configure a pin for a certain usage (although it may be called
anywhere).
Example
-------
::
int ledPin = 13; // LED connected to digital pin 13
void setup() {
pinMode(ledPin, OUTPUT); // sets the digital pin as output
}
void loop() {
digitalWrite(ledPin, HIGH); // sets the LED on
delay(1000); // waits for a second
digitalWrite(ledPin, LOW); // sets the LED off
delay(1000); // waits for a second
}
Arduino Compatibility
---------------------
.. TODO check out Arduino vs. Maple static discilpline cutoffs to
.. ensure accuracy of following:
The libmaple implementation of ``pinMode()`` supports the ``INPUT``
and ``OUTPUT`` modes with semantics identical to that of the Arduino
function (however, be advised that the Maple, as a 3.3V device, will
only drive 3.3V to an ``OUTPUT`` pin that has been set ``HIGH``).
``INPUT_ANALOG`` and ``PWM`` modes were added because the Maple does
not distinguish between analog and digital pins the same way the
Arduino does. Unlike the Arduino, you **must call** ``pinMode()`` to
set up a pin for these purposes before a call to, e.g.,
:ref:`lang-analogRead`. In practice, this should only add a few lines
to your :ref:`lang-setup` function.
.. TODO [0.1.0] verify following before putting it in:
.. ``OUTPUT_OPEN_DRAIN``, ``INPUT_PULLUP``, ``INPUT_PULLDOWN``, and
.. ``PWM_OPEN_DRAIN`` modes represent functionality not currently
.. available on Arduino boards.
See Also
--------
- :ref:`lang-constants`
- :ref:`lang-digitalwrite`
- :ref:`lang-digitalread`
- Maple :ref:`GPIO <gpio>` reference page
.. include:: /arduino-cc-attribution.txt
|
