1 files changed, 0 insertions, 64 deletions
diff --git a/src/stm32lib/examples/GPIO/IOToggle/readme.txt b/src/stm32lib/examples/GPIO/IOToggle/readme.txt
deleted file mode 100755
index e0637b0..0000000
--- a/src/stm32lib/examples/GPIO/IOToggle/readme.txt
+++ /dev/null
@@ -1,64 +0,0 @@
-/******************** (C) COPYRIGHT 2008 STMicroelectronics ********************
-* File Name          : readme.txt
-* Author             : MCD Application Team
-* Version            : V2.0.1
-* Date               : 06/13/2008
-* Description        : Description of the GPIO IOToggle Example.
-********************************************************************************
-* THE PRESENT FIRMWARE WHICH IS FOR GUIDANCE ONLY AIMS AT PROVIDING CUSTOMERS
-* WITH CODING INFORMATION REGARDING THEIR PRODUCTS IN ORDER FOR THEM TO SAVE TIME.
-* AS A RESULT, STMICROELECTRONICS SHALL NOT BE HELD LIABLE FOR ANY DIRECT,
-* INDIRECT OR CONSEQUENTIAL DAMAGES WITH RESPECT TO ANY CLAIMS ARISING FROM THE
-* CONTENT OF SUCH FIRMWARE AND/OR THE USE MADE BY CUSTOMERS OF THE CODING
-* INFORMATION CONTAINED HEREIN IN CONNECTION WITH THEIR PRODUCTS.
-*******************************************************************************/
-
-Example description
-===================
-This example describes how to use GPIO BSRR (Port bit set/reset register) and 
-BRR (Port bit reset register) for IO toggling.
-These registers allow modifying only one or several GPIO pins in a single atomic
-write access.
-
-
-Directory contents
-==================
-platform_config.h    Evaluation board specific configuration file
-stm32f10x_conf.h     Library Configuration file
-stm32f10x_it.c       Interrupt handlers
-stm32f10x_it.h       Header for stm32f10x_it.c
-main.c               Main program
-
-
-Hardware environment
-====================
-This example runs on STMicroelectronics STM3210B-EVAL and STM3210E-EVAL evaluation
-boards and can be easily tailored to any other hardware.
-To select the STMicroelectronics evaluation board used to run the example, uncomment
-the corresponding line in platform_config.h file.
-
- + STM3210B-EVAL 
-    - Use LD1, LD2, LD3 and LD4 leds connected respectively to PC.06, PC.07, PC.08
-      and PC.09 pins
- 
- + STM3210E-EVAL
-    - Use LD1, LD2, LD3 and LD4 leds connected respectively to PF.06, PF0.7, PF.08
-      and PF.09 pins
-
-    
-How to use it
-=============
-In order to make the program work, you must do the following:
-- Create a project and setup all your toolchain's start-up files
-- Compile the directory content files and required Library files:
-  + stm32f10x_lib.c
-  + stm32f10x_gpio.c
-  + stm32f10x_rcc.c
-  + stm32f10x_nvic.c
-  + stm32f10x_flash.c
-  
-- Link all compiled files and load your image into target memory
-- Run the example
-
-
-******************* (C) COPYRIGHT 2008 STMicroelectronics *****END OF FILE******