2 files changed, 8 insertions, 10 deletions

diff --git a/docs/source/hardware/maple-ret6.rst b/docs/source/hardware/maple-ret6.rst
index 1f3a656..d6a7c0e 100644
--- a/docs/source/hardware/maple-ret6.rst
+++ b/docs/source/hardware/maple-ret6.rst
@@ -279,10 +279,10 @@ This section lists known issues and warnings for the Maple RET6 Edition.
   the board's built-in LED; this is the same GPIO bit which is
   connected to the DAC's channel 2 output.
 
-* **Reset and NJTRST tied together**: The MCU's reset pin is tied to
-  PB4, the NJTRST (JTAG reset) pin, which is pin 43.  Thus, attempting
-  to use pin 43 as a GPIO will reset your board (and also prevents the
-  JTAG "reset halt" command from working properly).
+* **Reset and NJTRST tied together**: The MCU's reset pin is connected
+  to PB4, the NJTRST (JTAG reset) pin, which is pin 43.  Thus,
+  attempting to use pin 43 as a GPIO will reset your board (and also
+  prevents the JTAG "reset halt" command from working properly).
 
 Recommended Reading
 -------------------
diff --git a/docs/source/hardware/maple.rst b/docs/source/hardware/maple.rst
index 2ae1c30..d0434ab 100644
--- a/docs/source/hardware/maple.rst
+++ b/docs/source/hardware/maple.rst
@@ -322,12 +322,10 @@ Rev 5
   from its silkscreen.  This mistake was fixed in later manufacturing
   runs.
 
-* **Reset and NJTRST tied together**: The MCU's reset pin is tied to
-  PB4, the NJTRST pin, which is pin 43.  Thus, attempting to use pin
-  43 as a GPIO will reset your board (and also prevents the JTAG
-  "reset halt") command from working properly.  It's possible to cut
-  the trace, but doing so will damage your board, so we *do not
-  recommend it* unless you're very sure about what you're doing.
+* **Reset and NJTRST tied together**: The MCU's reset pin is connected
+  to PB4, the NJTRST pin, which is pin 43.  Thus, attempting to use
+  pin 43 as a GPIO will reset your board (and also prevents the JTAG
+  "reset halt") command from working properly.
 
 Rev 3
 ~~~~~