From 4e90248a2e81ec7bd8d3cfa858cef4a045cc1003 Mon Sep 17 00:00:00 2001 From: Marti Bolivar Date: Sun, 27 Feb 2011 11:42:56 -0500 Subject: Cleaned out libmaple.h; this had wide-ranging implications. Many of the #defines in libmaple.h were board-specific, not MCU-specific. Most of these were only used by code under libmaple/usb/. These were moved into usb_config.h, and are clearly marked as being terrible hacks. I'm going to treat the USB stack as a black box that we'll deal with later. Further, instead of having a variety of #defines like "How many USARTS do I have?", we decide that based on the density of the chip. This is determined by testing for STM32_MEDIUM_DENSITY or STM32_HIGH_DENSITY defines. libmaple currently doesn't support low-density chips, so that suffices. The Makefile will set these automatically based on the MCU. Other offending #defines are ERROR_LED_PORT and ERROR_LED_PIN; these were made optional, but they're set in the Makefile as a hack to keep things working. --- libmaple/usart.c | 12 ++++++++---- 1 file changed, 8 insertions(+), 4 deletions(-) (limited to 'libmaple/usart.c') diff --git a/libmaple/usart.c b/libmaple/usart.c index 44a5c92..030d3cc 100644 --- a/libmaple/usart.c +++ b/libmaple/usart.c @@ -61,7 +61,7 @@ struct usart_dev usart_dev_table[] = { .rcc_dev_num = RCC_USART3, .nvic_dev_num = NVIC_USART3 }, -#if NR_USART >= 5 +#ifdef STM32_HIGH_DENSITY /* TODO test */ [UART4] = { .base = (usart_port*)UART4_BASE, @@ -107,7 +107,7 @@ void USART3_IRQHandler(void) { usart_irq(USART3); } -#if NR_USART >= 5 +#ifdef STM32_HIGH_DENSITY void UART4_IRQHandler(void) { usart_irq(UART4); } @@ -124,7 +124,11 @@ void UART5_IRQHandler(void) { * @param baud Baud rate to be set at */ void usart_init(uint8 usart_num, uint32 baud) { - ASSERT(usart_num <= NR_USART); +#ifdef STM32_HIGH_DENSITY + ASSERT(usart_num <= UART5); +#else + ASSERT(usart_num <= USART3); +#endif usart_port *port; ring_buffer *ring_buf; @@ -170,7 +174,7 @@ void usart_disable_all() { usart_disable(USART1); usart_disable(USART2); usart_disable(USART3); -#if NR_USART >= 5 +#ifdef STM32_HIGH_DENSITY usart_disable(UART4); usart_disable(UART5); #endif -- cgit v1.2.3