From 03ad1753053f6fc8a46d88bf20c6690619e1d54d Mon Sep 17 00:00:00 2001 From: Marti Bolivar Date: Fri, 13 May 2011 17:44:46 -0400 Subject: Docs: Removing note about cutting the Maple's NJTRST<->NRST trace. Worried about the possibility of an attractive nuisance. --- docs/source/hardware/maple.rst | 10 ++++------ 1 file changed, 4 insertions(+), 6 deletions(-) (limited to 'docs/source/hardware/maple.rst') diff --git a/docs/source/hardware/maple.rst b/docs/source/hardware/maple.rst index 2ae1c30..d0434ab 100644 --- a/docs/source/hardware/maple.rst +++ b/docs/source/hardware/maple.rst @@ -322,12 +322,10 @@ Rev 5 from its silkscreen. This mistake was fixed in later manufacturing runs. -* **Reset and NJTRST tied together**: The MCU's reset pin is tied to - PB4, the NJTRST pin, which is pin 43. Thus, attempting to use pin - 43 as a GPIO will reset your board (and also prevents the JTAG - "reset halt") command from working properly. It's possible to cut - the trace, but doing so will damage your board, so we *do not - recommend it* unless you're very sure about what you're doing. +* **Reset and NJTRST tied together**: The MCU's reset pin is connected + to PB4, the NJTRST pin, which is pin 43. Thus, attempting to use + pin 43 as a GPIO will reset your board (and also prevents the JTAG + "reset halt") command from working properly. Rev 3 ~~~~~ -- cgit v1.2.3