From 41a93d13f0c89b00b90a492c24c9576e93cebafd Mon Sep 17 00:00:00 2001 From: Marti Bolivar Date: Mon, 23 May 2011 16:29:50 -0400 Subject: Docs: maple-ret6.rst touchups. --- docs/source/hardware/maple-ret6.rst | 6 ++++-- 1 file changed, 4 insertions(+), 2 deletions(-) diff --git a/docs/source/hardware/maple-ret6.rst b/docs/source/hardware/maple-ret6.rst index 5bd00f1..9ee46d2 100644 --- a/docs/source/hardware/maple-ret6.rst +++ b/docs/source/hardware/maple-ret6.rst @@ -329,6 +329,8 @@ This section lists known issues and warnings for the Maple RET6 Edition. that of the Maple Rev 5, which wasn't designed for use with these STM32F103RET6-only peripherals. +.. _maple-ret6-dac-ch2: + * **DAC channel 2 on BOARD_LED_PIN**: The Maple Rev 5 connects PA5 to the board's built-in LED; this is the same GPIO bit which is connected to the DAC's channel 2 output. This is also due to the @@ -336,8 +338,8 @@ This section lists known issues and warnings for the Maple RET6 Edition. .. _maple-ret6-nrst-pb4: -* **Reset and PB4 tied together**: The Maple's reset line is also - connected to PB4, which is labeled on the silkscreen as pin 43. +* **Reset and PB4 tied together**: The RET6 Edition's reset line is + also connected to PB4, which is labeled on the silkscreen as pin 43. Thus, attempting to use pin 43 as a GPIO may reset your board. This has other implications. Since PB4 is also the JTAG NJTRST line, this prevents the :ref:`JTAG ` "reset halt" command from -- cgit v1.2.3