1 files changed, 0 insertions, 56 deletions
diff --git a/docs/source/lang/api/digitalwrite.rst b/docs/source/lang/api/digitalwrite.rst
deleted file mode 100644
index bae8db9..0000000
--- a/docs/source/lang/api/digitalwrite.rst
+++ /dev/null
@@ -1,56 +0,0 @@
-.. highlight:: cpp
-
-.. _lang-digitalwrite:
-
-digitalWrite()
-==============
-
-Write a :ref:`HIGH <lang-constants-high>` or a :ref:`LOW
-<lang-constants-low>` value to a pin configured as :ref:`OUTPUT
-<lang-constants-output>`.
-
-Library Documentation
----------------------
-
-.. doxygenfunction:: digitalWrite
-
-Discussion
-----------
-
-If the pin has been configured as an ``OUTPUT`` with :ref:`pinMode()
-<lang-pinmode>` its voltage will be set to the corresponding value:
-3.3V for ``HIGH``, and 0V (ground) for ``LOW``.
-
-Because it is soldered to an LED and resistor in series, your board's
-:ref:`BOARD_LED_PIN <lang-board-values-led>` will respond slightly
-more slowly as an output than the other pins.
-
-Example
--------
-
-The following example sets the built-in LED pin to ``HIGH``, makes a
-one-second-long delay, sets the pin back to ``LOW``, and delays again,
-causing a blinking pattern (you could also use
-:ref:`lang-toggleled`)::
-
-    void setup() {
-      pinMode(BOARD_LED_PIN, OUTPUT);      // sets the digital pin as output
-    }
-
-    void loop() {
-      digitalWrite(BOARD_LED_PIN, HIGH);   // sets the LED on
-      delay(1000);                         // waits for a second
-      digitalWrite(BOARD_LED_PIN, LOW);    // sets the LED off
-      delay(1000);                         // waits for a second
-    }
-
-See Also
---------
-
-- :ref:`pinMode <lang-pinmode>`
-- :ref:`digitalRead <lang-digitalread>`
-- :ref:`BOARD_LED_PIN <lang-board-values-led>`
-- :ref:`lang-toggleled`
-- :ref:`lang-togglepin`
-
-.. include:: /arduino-cc-attribution.txt