aboutsummaryrefslogtreecommitdiffstats
path: root/wirish/boards/olimex_stm32_h103/board.cpp
diff options
context:
space:
mode:
authorMarti Bolivar <mbolivar@leaflabs.com>2012-03-26 15:42:25 -0400
committerMarti Bolivar <mbolivar@leaflabs.com>2012-04-11 16:56:55 -0400
commiteee763308a497105a1aa1aefd3c4b3124e8362b3 (patch)
treedb2381ab15276a26e009e12f8ffb44c38b95229c /wirish/boards/olimex_stm32_h103/board.cpp
parent45763badb4ff7cee56a38b72d7546eae4205630b (diff)
downloadlibrambutan-eee763308a497105a1aa1aefd3c4b3124e8362b3.tar.gz
librambutan-eee763308a497105a1aa1aefd3c4b3124e8362b3.zip
[FIXME] Resurrected, shinier USART support.
FIXME: - Test F1 support - Solve problem of duplicated bytes being TXed unless delay is inserted after configuration but before first bytes are TXed. Rip out nonportable bits from top-level interfaces. The USART register maps are basically the same between F1 and F2, so leave these, but add register bit definitions which had name changes to the libmaple header to avoid needless repetition. There are also a few new bits in the F2 USART registers; add definitions for these in the F2 USART header. Add Doxygen comments for all USART bit definitions. Deprecate struct usart_dev's max_baud field. This is just bloat that doesn't bring us much real benefit. Add new series-specific USART files for F1 and F2: - libmaple/stm32f[1,2]/usart.c - libmaple/stm32f[1,2]/include/series/usart.h These are standard series-specific files, providing register map base pointers, defining devices, implementing nonportable routines, etc. We need a portable way to configure the USART GPIOs. To this end, add usart_async_gpio_cfg() to the top-level USART interface. This function is implemented in new F1 and F2 USART backends to take the appropriate action to configure the RX and TX pins for asynchronous full duplex mode. USART baud rate calculation is done differently on the different series. Keep the usart_set_baud_rate() declaration in the top-level USART header, but move the implementations into the series-specific usart.c files. In usart_set_baud_rate(), allow for deriving clock_speed automatically by letting user tell us to figure out the peripheral clock speed by mapping the device's rcc_clk_id onto an STM32_PCLK[1,2] value. This preserves flexibility for users with non-default clock configurations, but makes things easier on everyone else. Add private USART files for portable private USART routines: - libmaple/usart_private.h - libmaple/usart_private.c Signed-off-by: Marti Bolivar <mbolivar@leaflabs.com>
Diffstat (limited to 'wirish/boards/olimex_stm32_h103/board.cpp')
0 files changed, 0 insertions, 0 deletions