From b53b228af82b9580ddd3fe14a491dfe8dcafabb0 Mon Sep 17 00:00:00 2001
From: bnewbold <bnewbold@robocracy.org>
Date: Wed, 12 Sep 2012 17:25:45 +0200
Subject: moved stuff around

---
 hardware/specs.page | 58 -----------------------------------------------------
 1 file changed, 58 deletions(-)

(limited to 'hardware/specs.page')

diff --git a/hardware/specs.page b/hardware/specs.page
index 69dde51..b5a16e4 100644
--- a/hardware/specs.page
+++ b/hardware/specs.page
@@ -1,61 +1,3 @@
 
-Below is the best-guess set of features that a rooter hardware device would
-include; this is a balance between good functionality, engineering feasibility,
-and cost at the 1k or 10k production batch size:
-
- - Core
-    - ARM SoC, Freescale i.MX6
-    - Power management/regulator IC for SoC
-    - 512MB RAM
-    - No onboard FLASH, 8GB+ uSD card
-    - FRAM chip for routing table persistance
- - WiFi
-    - full-size miniPCIe slot for off-the-shelf dual-band card
- - 802.15.4 
-    - all-in-one stm32w chip, trace antenna (?)
- - Ethernet
-    - GigE switch chip w/ PHY, 5 ports
-    - 4x LAN jacks with drivers for longer cable runs (w/ LEDs)
-    - 1x WAN jack
- - Power
-    - 5/12v regulator, ~1amp
-    - Power connector
-    - Reverse voltage diode
- - USB Host jack
- - USB mini jack for UART/JTAG/Mass storage (how? USB2 hub?)
- - Second SD or uSD connector (for expansion)
- - status LEDs and drivers (PWM from SoC?)
- - reset button
- - power switch
-
 # Absolute Minimal Hardware
 
-A device with the minimal hardware resources required to accomplish rooter
-goals, which could be implemented with as little engineering as possible. This
-would be very similar to the $90 open hardware BeagleBone development board;
-than design could be copied and extended.
-
- - Core
-    - ARM SoC, probably BeagleBoard-compatible device
-    - power management/regulator IC for SoC
-    - 256MB RAM
-    - No onboard FLASH, 2GB+ uSD card
- - WiFi
-    - Atheros ath5k-compatible WiFi bg baseband, radio
-    - Antenna connector
-    - regulator/powermanagement
- - 802.15.4 
-    - all-in-one chip, trace antenna (?)
- - Ethernet
-    - PHY IC
-    - Single 10/100mbps jack (w/ LEDs)
-    - Connectors with LEDs
- - Power
-    - 5/12v regulator, ~1amp
-    - Power connector
-    - Reverse voltage diode
- - Second SD or uSD connector (for expansion)
- - status LEDs and drivers (PWM from SoC?)
- - reset button
- - power switch
-
-- 
cgit v1.2.3